Page 1 of 1

workshop jacking points

Posted: Wed Nov 08, 2017 11:53 am
by davefiatforum
Hi has anyone got one of them diagrams for the workshop jacking points on a J11? i searched google and found some for other nissans but not for a quashqui. Had a tyre fitters try and put trolley jacks on the sills yesterday :shock:

Re: workshop jacking points

Posted: Wed Nov 08, 2017 12:28 pm
by Gel
Read your manual perhaps; on mine, this is covered in Sect. 6-4.

Re: workshop jacking points

Posted: Wed Nov 08, 2017 3:14 pm
by Hound

lifting.jpg


Re: workshop jacking points

Posted: Thu Nov 09, 2017 10:26 am
by davefiatforum
thanks

Re: workshop jacking points

Posted: Thu Nov 09, 2017 10:32 am
by davefiatforum
Gel wrote: Wed Nov 08, 2017 12:28 pm Read your manual perhaps; on mine, this is covered in Sect. 6-4.
strange i was looking at pdf version of the manual and there was only scissor jack points

Re: workshop jacking points

Posted: Thu Nov 09, 2017 9:33 pm
by Hound
strange i was looking at pdf version of the manual and there was only scissor jack points
My illustration was from the service manual and shows the additional front and rear jack/support points.
Numbers 1 and 2 are the scissor jack points. No other side points are shown in either manual.

1.jpg

2.jpg

3.jpg

4.jpg

In my previous post it also showed one side being lifted by using both side scissor points simultaneously.

Re: workshop jacking points

Posted: Sun Nov 12, 2017 10:10 pm
by Deleted User 3871
Hound

Thanks for showing the jacking board. Where it touches the car appears to be exactly where the paint is missing from the sills on my QQ. There is still at least another layer of pint remaining so I'm not to bothered, will probably get it sorted just before the car turns 3 and warranty runs out.
Hound wrote: Wed Nov 08, 2017 3:14 pmlifting.jpg

Re: workshop jacking points

Posted: Sun Dec 24, 2017 9:32 am
by Moviestar
Hi all noticed in the Tyre's section people are using these to protect the underneath etc:
https://www.ebay.co.uk/itm/Pinch-seam-e ... SwDlxU3SiY

Re: workshop jacking points

Posted: Sun Dec 24, 2017 3:51 pm
by switchback
That looks like a good idea.

Re: workshop jacking points

Posted: Sun Nov 19, 2023 11:49 pm
by Kingtrout
So you have to remove the plastic under shield/cover in order to use the front jacking point in order to use a trolley jack..?