Hi,
Started car after 3 weeks of no use to find a bunch of warnings/system faults posted -
Chassis control system (no picture)
Traffic sign recognition
Blind spot warning
Forward emergency braking
Start/Stop
I assume that these are all connected - I guess it could be as simple as low battery voltage (I will go and check this soon).
Has anyone else seen this and got any other suggestions?
Apologies about picture orientation.
System faults after 3 week holiday
Found the problem - some animal has chewed through the rear driver's side ABS sensor cable!
My Wife found pieces of cable on our drive after I'd gone out.
Need to source a new ABS sensor cable and repair the loom.
Unfortunately, one cut is so close to the connector that I will need part of the in car wiring loom.
My Wife found pieces of cable on our drive after I'd gone out.
Need to source a new ABS sensor cable and repair the loom.
Unfortunately, one cut is so close to the connector that I will need part of the in car wiring loom.
2015 Tekna 1.6dCi in Pearl Black (plus Brink/Thule detachable towbar)
-
- Posts: 382
- Joined: Sun Dec 27, 2015 3:08 pm
- Location: East Anglia
Don't want to worry you but I'd say the wires had been cut rather than chewed by an animal.............................and what about that huge dented and deformed crossmember
2015 1.6 dci Tekna, AWD.
I've looked again at the wires and there are definitely signs of teeth marks.
Dented crossmember is a camera trick - crossmember is fine.
I appreciate your concerns though.
Does anyone have access to a scrap J11 model?
I need part of the wiring loom to repair this mess - happy to pay costs.
Piece needed is from from inside the boot (RH side) to the first connector - approx. 6" long.
Please see photo of where it needs to be cut.
It would be great to have the rear wheel sensor/cable assembly as well (part 47900-4EA0A) but I can buy a new one of these if necessary.
Thanks Jerry
Dented crossmember is a camera trick - crossmember is fine.
I appreciate your concerns though.
Does anyone have access to a scrap J11 model?
I need part of the wiring loom to repair this mess - happy to pay costs.
Piece needed is from from inside the boot (RH side) to the first connector - approx. 6" long.
Please see photo of where it needs to be cut.
It would be great to have the rear wheel sensor/cable assembly as well (part 47900-4EA0A) but I can buy a new one of these if necessary.
Thanks Jerry
2015 Tekna 1.6dCi in Pearl Black (plus Brink/Thule detachable towbar)
- Gel
- Posts: 3265
- Joined: Thu May 22, 2014 12:02 pm
- Location: Thames Valley UK
- Qashqai Model: Mk.2 Qashqai - J11 (2013–2017)
There's a recent thread here entitled 'Qashqai Murdered;' drop a PM to forum member and he may be able to find out which scrappie the deceased vehicle went to.
Or try one of the many who now operate on line & offer a mail order service:-
eg
https://www.1stchoice.co.uk/car-parts/nissan
Or try one of the many who now operate on line & offer a mail order service:-
eg
https://www.1stchoice.co.uk/car-parts/nissan
2014-19 J11A-14 1.5dci Ink Blue Tekna owner; now departed for a Mazda CX-5 GT Sport Nav, 2.0L Petrol