Tyre pressure indicators
It has got it, I just forgot to take a photo as it is only active when the car is moving (15MPH?)Shows a picture of the car with Target and actual measured for each wheel. Can set to PSI, bar as you like.My targets were as expected (2.3 bar front, 2.1 bar rears) actual cold was 0.1 bar above for all wheels.
Now 1.3 petrol Tekna + Gunmetal (Oct-2022)
Was 1.5dci Tekna+ Gunmetal (March 2018)
Was 1.5dci Acenta Premium Magnetic Red (March 2014)
Was 1.5dci Tekna+ Gunmetal (March 2018)
Was 1.5dci Acenta Premium Magnetic Red (March 2014)
-
- Posts: 574
- Joined: Wed Jan 15, 2014 3:09 pm
Interesting as I've not seen target on mine..but pretty sure I did check mine when it was parked.....
Driving a 1.5DCi Tekna in Blade Silver since 14/02/2014
Yep, its one of the available screens on the drivers dash. Mine are set to 32F / 30 R (psi) however I have seen as much as 5psi difference when the tyres are warm. I knew they went up as they got warm but didn't realise by that much!The sensors will auto configure, so when you drive the car it calibrates the location so even if you move your rears to your fronts, the display should always be correct! If you need a new sensor, again no programming needed, it will just pick it up as you drive!To get the readings, you need to have driven on a smoothish surface above 15mph (or something like that) for a couple of minutesSome people suggest they are not 100% accurate so use it more as a guide, but mine seem to be quite close to the mark so far!
-
- Posts: 574
- Joined: Wed Jan 15, 2014 3:09 pm
Interesting I'm sure mine are showing at 41 when I checked last.Not even sure what they are supposed to be...man I've been so lazy with this car so far lol
Driving a 1.5DCi Tekna in Blade Silver since 14/02/2014
-
- Posts: 574
- Joined: Wed Jan 15, 2014 3:09 pm
I think it reports pressures after you've driven a bit. Even when stopped.
Driving a 1.5DCi Tekna in Blade Silver since 14/02/2014